Kuro Coil Builder is a revolutionary coil builder that turns you into a master coil builder in minutes. Ultra functionary auto coiler that will create tight, uniform coils in just seconds. Build from 20 - 28 Gauge rounded kanthal and nickel wire or any low resistant wires like G-Plat, Royal or Hot wire with just the twist of your finger. This high grade coiler produces the perfect coil with every single twist.
Get that perfect micro coil in seconds, each and every timeLight weight and portable, perfect for traveling, and on the goUnique styling with stylish Colours Comes with 6 different post sizes: 1.0mm, 1.5mm, 2.0mm, 2.5mm, 3.0mm, 3.5mm
How to Use:
Insert the socket screw into the appropriate hole of the winder section Insert wire through hole on the side of the handle. Leave about 1/2" of the wire protruding from the hole. Hold the end of the wire against the handle so it won't pull through Pull the loose end of the wire around the shaft Slide the winder section over the shaft with the pin facing toward the handle Turn the winder section so that it catches the wire and starts wrapping it around the shaft. Keep light pressure against handle while winding. Excessive pressure will force smaller gauge wire to wrap over itself. When finished, remove winder and straighten the wire end that protrudes from the hole in the handle Push up on the wire to slide coil up. Carefully grab the coil at the bottom to slide it off the shaft Note: The coiler winds the coils with the loops touching each other. This can initially give wrong resistance values without first burning in the coil. Care must be taken when first firing the device with a new coil. Carefully pulse the device to bring temperature up slowly so you do not create a "hot leg" and melt the coil. Rake the coils lightly in between pulsing to improve the break in process. Pre-burning or oxidizing the wire before making the coil may also help.